Some photos od each part weighted separatly in grams.

First, I mounted servo rudder tray and set in TX sub trim and travel adjust. Elevator wires in place so I can close tail of plane. Tail landing gear mounted, too. 

Futaba servos in place, mounted and set in Tx. Ready for flying.

Hacker motor mounted. This plane was made oryginally for ContraRotor motor so a little ugly with regular motor with single propeller.

At last elevator servos arrived so can finish horizontal stabs. I used double side tape to stick pushrod cowl.

Horizontal stabs mounted and finished. Tail of plane ready in 100%.

Main ladning gear done. 6 x M4 screws, washers and nuts. I measured distance from tail wheel to main wheels axle to get the same distance between both wheels.

Today, I installed receiver and batteries switch which was custom made by PB and gives 6,6V for servos.

Galactika ready for CG checking. In that plane there is only one spot suitable for battery, I have put the battery there and lifted plane... I managed to find best place for battery at once to achievie correct CG.  

Last thing I must do is a main battery tray.

Battery tray already mounted, now plane is ready and waiting for suitable weather for maiden flights.

I did 8 flights and I have to tell that it is really great model plane. It needs time and many setups in radio and soon should fly as I wish.